Shindaiwa 65010 Operator's Manual download pdf (Page 10)

10

Inspect the Gearcase Protector

The metal gearcase protector (L) is

installed to protect the gearcase ange

from damage when working close to

sidewalks or other abrasive surfaces,

and should be routinely inspected for

damage or excessive wear.

When replacing the protector, inspect to

be sure that both of the protector mount-

ing screws are rmly tightened and each

screw is locked in place with a nut as

shown.

L

D

B

C

E

Replacing the edger blade

Align the hole in holder A (A) with 1.

the matching hole in the gearcase

and then use a hex wrench to tem-

porarily lock the output shaft.

Loosen the shaft bolt then remove 2.

the output shaft bolt (C), Holder B

(B) and the edger blade (D) from

the gearcase.

Mount the edger blade and holder 3.

B (B) onto the shaft, and then

install the bolt guard (E) and shaft

bolt (turn bolt counterclockwise to

install).

Align the hole in holder A (A) with 4.

the matching hole in the gearcase,

and then use a hex wrench to tem-

porarily lock the output shaft.

Firmly tighten the shaft bolt. 5.

Remove the hex wrench.

WARNING!

Always wear gloves when

handling the edger blade.

A

1 2 ... 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments