Shindaiwa LE242/EVC Operator's Manual download pdf (Page 11)

Remove all dirt and debris from the engine and check the cooling ns

Cooling

ns

Air

intake

Cooling

ns

11

Maintenance

WARNING!

Before performing any main-

tenance, repair, or cleaning work on the

unit, make sure the engine and cutting

attachment are completely stopped. Dis-

connect the spark plug wire before per-

forming service or maintenance.

WARNING!

Non-standard accessories,

cutting attachment, or replacement

parts may not operate properly with

your unit and may cause damage and

lead to personal injury.

Prior to each work day, perform the

following:

Remove all dirt and debris from the

■

engine, check the cooling ﬁns and

air cleaner for clogging, and clean as

necessary.

Clean any debris or dirt from the cut-

■

ting attachment.

Check the entire unit for leaking fuel or

■

grease.

Check for loose or missing screws or

■

components. Make sure the cutter

attachment is securely fastened.

Make sure nuts, bolts, and screws

■

(except carburetor idle speed adjusting

screws) are tight.

Carefully remove any accumulations of

■

dirt or debris from the mufﬂer and fuel

tank. Check cooling air intake area at

base of crankcase. Remove all debris.

Dirt build-up in these areas can lead to

engine overheating, ﬁre, or premature

wear.

Daily Maintenance

IMPORTANT!

MAINTENANCE, REPLACEMENT

OR REPAIR OF EMISSION CONTROL

DEVICES AND SYSTEMS MAY BE PER-

FORMED BY ANY REPAIR ESTABLISH-

MENT OR INDIVIDUAL; HOWEVER, WAR-

RANTY REPAIRS MUST BE PERFORMED

BY A DEALER OR SERVICE CENTER

AUTHORIZED BY Shindaiwa INC. THE USE

OF PARTS THAT ARE NOT EQUIVALENT

IN PERFORMANCE AND DURABILITY

TO AUTHORIZED PARTS MAY IMPAIR

THE EFFECTIVENESS OF THE EMISSION

CONTROL SYSTEM AND MAY HAVE A

BEARING ON THE OUTCOME OF A WAR-

RANTY CLAIM.

Spark Plug

Keep the spark plug and wire connections

tight and clean.

Fasteners

Make sure nuts, bolts, and screws (except

carburetor adjusting screws) are tight.

Blades

Keep blades sharp and check blade

condition frequently. If a blade’s per-

formance changes suddenly, stop the

engine and check the blade for cracks or

other damage. Replace a damaged blade

IMMEDIATELY!

Mufer

This unit must never be operated with a

faulty or missing spark arrester or muf-

ﬂer. Make sure the mufﬂer is well secured

and in good condition. A worn or damaged

mufﬂer is a ﬁre hazard and may also cause

hearing loss.

General Maintenance

Never repair a damaged blade by ■

welding, straightening, or by modify-

ing its shape. An altered blade may

break during operation, resulting in

serious personal injury.

Blades are not interchangeable ■

between Shindaiwa edgers and

trimmer/brushcutter models.

Operating any unit with a blade

or attachment not approved for

that unit can be hazardous and

may cause serious injury.

WARNING!

NOTE:

Using non-standard replacement parts

could invalidate your Shindaiwa warranty.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 59 60

Comments to this Manuals

No comments