Shindaiwa 78701 Operator's Manual

SHINDAIWA OWNER’S/OPERATOR’S MANUALMinimize the risk of injury to yourself and others! Read this manual and familiarize yourself with the contents.

101. Place the re-gripped T230, PB230, or AH230 on a clean, flat surface in an upright position.For the T230/T231 Trimmers: 2. Loosen, but don't

11Apply the adhesive caution labelsFigure 211. Clean outer tube so the labels will adhere properly. 2. Peel the backing off the multiple warning lab

12Installing and Adjusting the Bar and ChainInstalling The Chain WARNING!Never attempt to install, replace, or adjust the chain with the engine runnin

13WARNING!Never attempt to install, replace, or adjust the chain with the engine running. WARNING!The saw chain is very sharp. Wear gloves to protect

14Adjusting Oil Flow RateDERelieving Cut:To avoid tearing the bark, kickback or pinching the bar when pruning thick branches, always start by performi

15Flush-cutting Thick Branches:If branch diameter is more than 10 cm, first perform undercut (3) and cross-cut at a distance (A) of about 25 cm from th

16WARNING!Before performing any maintenance, repair, or cleaning work on the unit, make sure the engine and cutting attachment are completely stopped.

17 Lubricate the gearcase. To perform this operation, first remove the gearcase from the upper outer tube as follows.CAUTION!Do not remove the D-shap

18A30°90°(TOP PLATE ANGLE)(DEPTH GAUGE)(TOP PLATE CUTTING ANGLE)Sharpening InstructionsIMPORTANT!File all the cutters to the same angle and depth! Une

19ADDITIONAL PROBLEMSSymptomPossible CauseRemedyTroubleshooting GuideEngine idle too high.Broken clutch spring or worn clutch spring boss.Warped or da

2Throughout this manual are special at-tention statements. DANGER!A statement preceded by the trian-gular attention symbol and the word “DANGER” indic

20

21

ECHO Incorporated.400 Oakwood RoadLake Zurich, IL 60047-1564 U.S.A.Telephone: 1-877-986-7783Fax: 1-847-540-8416www.shindaiwa.com Yamabiko Corporation

3CAUTION! Always maintain the Pole Pruner Tool according to this owner’s manual and follow the recommended scheduled maintenance.  Never modify or

4Safety LabelsIMPORTANT!Safety and Information Labels: Make sure all safety and information labels are undamaged, readable and up to date. Immediately

5Product DescriptionIMPORTANT!The terms “left”, “left-hand”, and “LH”; “right”, “right-hand”, and “RH”; “front” and “rear” refer to directions as view

6SpecicationsLength mounted on T230 w/10 inch bar ... 1991 mm (78.4 in)Dry Weight (Tool only)with bar and chain...0.91 kg (2.0 lbs)Guide

7Figure 8Loosen the three throttle lever clamp screwsSlice the grip to removeInstalling The Interlock Throttle Grip To avoid serious injury, grip th

8Lower TubeTube ClampClamp ScrewHandle GripThrottle Cable AssemblyMain Shaft3. Position the outer tube so the stop switch is facing up and the thrott

9Adjusting the Throttle Cable1. Loosen the two 10mm throttle cable nuts at the fan cover as shown in Figure 16.Idle Throttle Position1/4-inch Throttl