Shindaiwa X7502800900 Operator's Manual download pdf (Page 11)

XST013

Starting the Engine

4. While holding the outer tube ﬁrmly

with left hand. Use your other hand

to slowly pull the recoil starter

handle until resistance is felt, then

pull quickly to start the engine.

Make sure

the cutting

attachment

is clear of

obstructions!

IMPORTANT!!

Engine ignition is controlled by a two position switch mounted on the throttle housing labeled, “I” for ON or START and

“O” for OFF or STOP.

Figure 14

Figure 17

IMPORTANT!

The primer system only pushes fuel

through the carburetor. Repeatedly

pressing the primer bulb will not ﬂood

the engine with fuel.

CAUTION!

Do not pull the recoil starter to the

end of the rope travel. Pulling the

recoil starter to the end of the rope

travel can damage the starter.

Slide the ignition switch to the “I” 1.

position. See Figure 14.

Press the primer bulb until fuel can 2.

be seen ﬂowing in the transparent

return tube.

3. Set the choke lever to the CLOSED

position if engine is cold.

Figure 16

Closed

Primer Bulb

Return Tube

Figure 15

WARNING!

Never start the engine from

the operating position.

WARNING!

The cutting attachment may

rotate when the engine is started!

Figure 18

Open

5. When the engine starts, slowly

move the choke lever to the “OPEN”

position. See Figure 18. (If the engine

stops after the initial start, close the

choke and restart.)

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Comments to this Manuals

No comments

Shindaiwa X7502800900 Operator's Manual Page 11

Comments to this Manuals

Related products and manuals for Garden tools Shindaiwa X7502800900