Shindaiwa X7502800900 Operator's Manual download pdf (Page 20)

ADDITIONAL PROBLEMS

Poor acceleration.

Clogged air ﬁ lter.

Clogged fuel ﬁ lter.

Lean fuel/air mixture.

Idle speed set too low.

Ignition switch turned off.

Fuel tank empty.

Water in the fuel.

Clogged fuel ﬁ lter.

Shorted spark plug or loose terminal.

Ignition failure.

Piston seizure.

Ground (stop) wire is disconnected,

or switch is defective.

Overheating due to incorrect spark plug.

Overheated engine.

Clean the air ﬁ lter.

Replace the fuel ﬁ lter.

Consult with an authorized Shindaiwa

servicing dealer.

Adjust idle. Check Speciﬁ cations page for correct idle speed.

Reset the switch and re-start.

Reﬁ ll with fresh, clean unleaded gasoline with a pump octane

of 89 or higher mixed with an air cooled engine oil that

meets or exceeds ISO-L-EGD and/or JASO FD classiﬁ ed oils

at 50:1 gasoline/oil ratio.

Replace fuel ﬁ lter.

Clean or replace spark plug. Check the Speciﬁ cations section

for the correct plug and gap for your unit. Tighten

the terminal.

Replace the ignition unit.

Consult with an authorized Shindaiwa

servicing dealer.

Test and replace as required.

Replace the spark plug. Check the Speciﬁ cations section for

the correct plug and gap for your unit. Restart.

Idle engine until cool.

Symptom

Possible Cause

Remedy

Engine stops abruptly.

Engine difﬁ cult to shut off.

Troubleshooting Guide (continued)

Is the engine overheating?

Engine is rough at all

speeds. May also have

black smoke and/or

unburned fuel at the

exhaust.

Operator is overworking the unit.

Carburetor mixture is too lean.

Improper fuel ratio.

Fan, fan cover, cylinder ﬁ ns dirty

or damaged.

Carbon deposits on the piston or

in the mufﬂ er.

Clogged air cleaner element.

Loose or damaged spark plug.

Air leakage or clogged fuel line.

Water in the fuel.

Piston seizure.

Faulty carburetor and/or diaphragm.

Overheating condition.

Improper fuel.

Carbon deposits in the

combustion chamber.

Use a lower throttle setting.

Consult with an authorized Shindaiwa

servicing dealer.

Reﬁ ll with fresh, clean unleaded gasoline with a pump octane

of 89 or higher mixed with an air cooled engine oil that meets

or exceeds ISO-L-EGD and/or JASO FD classiﬁ ed oils at 50:1

gasoline/oil ratio.

Clean, repair or replace as necessary.

Consult with an authorized Shindaiwa

servicing dealer.

Service the air cleaner element.

Tighten or replace the spark plug.

Check the Speciﬁ cations section for the correct plug and gap

for your unit.

Repair or replace fuel ﬁ lter and/or

fuel line.

Reﬁ ll with fresh, clean unleaded gasoline with a pump octane

of 89 or higher mixed with an air cooled engine oil that meets

or exceeds ISO-L-EGD and/or JASO FD classiﬁ ed oils at 50:1

gasoline/oil ratio.

Consult with an authorized Shindaiwa servicing dealer.

Consult with an authorized Shindaiwa

servicing dealer.

Reﬁ ll with fresh, clean unleaded gasoline with a pump octane

of 89 or higher mixed with an air cooled engine oil that meets

or exceeds ISO-L-EGD and/or JASO FD classiﬁ ed oils at 50:1

gasoline/oil ratio.

Consult with an authorized Shindaiwa

servicing dealer.

What To Check

Possible Cause

Remedy

LOW POWER OUTPUT

Engine is knocking.

Troubleshooting Guide (continued)

Engine idle too high.

Broken clutch spring or worn clutch

spring boss.

Loose attachment holder.

Warped or damaged attachment.

Loose gearcase.

Cutting attachment

moves at engine idle.

Excessive vibration.

Cutting attachment will not

move.

Adjust idle. Check Speciﬁ cations page for correct idle

speed.

Replace spring/shoes as required, check idle speed.

Inspect and re-tighten holders securely.

Inspect and replace attachment as

required.

Tighten gearcase securely.

Bent main shaft/worn or damaged bushings.

Shaft not installed in powerhead or gearcase.

Broken shaft.

Damaged gearcase.

Inspect and replace as necessary.

Inspect and reinstall as required.

Idle set too high.

Adjust idle. Check Speciﬁ cations page for correct

idle speed.

Engine will not idle

down.

Engine has an air leak.

Consult with an authorized Shindaiwa servicing

dealer.

Consult with an authorized Shindaiwa servicing

dealer.

SHINDAIWA LIMITED WARRANTY STATEMENT FOR

PRODUCT SOLD IN USA AND CANADA BEGINNING 01/01/2010

ECHO, INC’S RESPONSIBILITY

ECHO Incorporated’s (ECHO, INC.) Limited Warranty, provides to the original purchaser that this Shindaiwa product is free from

defects in material and workmanship. Under normal use and maintenance from date of purchase, ECHO, INC. agrees to repair

or replace at it’s discretion, any defective product free of charge at any authorized Shindaiwa servicing dealer within listed below

application time periods, limitations and exclusions. THIS LIMITED WARRANTY IS ONLY APPLICABLE TO SHINDAIWA PROD-

UCTS SOLD BY AUTHORIZED SHINDAIWA DEALERS. IT IS EXTENDED TO THE ORIGINAL PURCHASER ONLY, AND IS

NOT TRANSFERABLE TO SUBSEQUENT OWNERS EXCEPT FOR EMISSION RELATED PARTS. Repair parts and accesso-

ries replaced under this warranty are warranted only for the balance of the original unit or accessory warranty period. Any dam-

age caused by improper installation or improper maintenance is not covered by this warranty. All parts or products replaced under

warranty become the property of ECHO, INC. This warranty is separate from the Emission control warranty statement supplied with

your new product. Please consult the Emission Control Warranty Statement for details regarding emission related parts. For a list

of Authorized Shindaiwa Dealers refer to WWW.SHINDAIWA.COM or call 1-877-986-7783.

OWNER’S RESPONSIBILITY

To ensure trouble free warranty coverage it is important that you register your Shindaiwa equipment on-line at WWW.SHINDAIWA.

COM or by  lling out the warranty registration card supplied with your unit. Registering your product con rms your warranty cover-

age and provides a direct link if we  nd it necessary to contact you.

The owner shall demonstrate reasonable care and use, and follow preventative maintenance, storage, fuel and oil usage as pre-

scribed in the operator’s manual. Should a product dif culty occur, you must, at your expense, deliver or ship your Shindaiwa unit

to an authorized Shindaiwa servicing dealer for warranty repairs (within the applicable warranty period), and arrange for pick-up

or return of your unit after the repairs have been made. For your nearest authorized Shindaiwa servicing dealer, call Shindaiwa’s

Dealer Referral Center, at 1-877-986-7783 or you can locate a Shindaiwa servicing dealer at WWW.SHINDAIWA.COM. Should you

require assistance or have questions concerning Shindaiwa’s Warranty Statement, you can contact our Consumer Product Support

Department at 1-800-673-1558 or contact us through the web at WWW.SHINDAIWA.COM.

PRODUCT WARRANTY PERIOD

RESIDENTIAL APPLICATION

• 2 YEAR WARRANTY - Units for residential, or non-income producing use will be covered by this limited warranty for

two (2) years from date of purchase.

EXCEPTIONS:

• For engine powered products, the electronic ignition module,  exible drive cable, and solid drive shaft are warranted for

the life* of the product on parts only.

• Cutting attachments such as, but not limited to, bars, chains, sprockets, tines, blades, PowerBroom

, belts, and nylon

trimmer heads for residential or non-income producing use will be covered for failures due to defects in material or

workmanship for a period of 60 days from original product purchase date. Any misuse from contact with concrete,

rocks, or other structures is not covered by this warranty.

• Multipurpose Tool Attachments carry the same warranty duration as the units they are designed to  t.

COMMERCIAL APPLICATION

• 90 DAY WARRANTY - All Chain Saws and Cut-Off Saws for commercial, institutional, agricultural, industrial, or income produc-

ing use will be covered by this limited warranty for 90 Days from the date of purchase.

• 2 YEAR WARRANTY - Units for commercial, institutional, agricultural, industrial, or income producing use will be covered by

this limited warranty for two (2) years from the date of purchase.

EXCEPTIONS:

• For engine powered products, the electronic ignition module,  exible drive cables, and solid drive shafts are warranted

for the life* of the product on parts only.

• Cutting attachments such as, but not limited to, bars, chains, sprockets, tines, blades, PowerBroom

, belts, and nylon

trimmer heads for commercial, institutional, agricultural, industrial, rental, or income producing will be covered for fail-

ures due to defects in material or workmanship for a period of 30 days from original product purchase date. Any misuse

from contact with concrete, rocks, or other structures is not covered by this warranty.

• Multipurpose Tool Attachments carry the same warranty duration as the units they are designed to  t.

RENTAL APPLICATION - 90 DAYS WARRANTY

• Units for rental use will be covered against defects in material and workmanship for a period of 90 days from the date of pur-

chase.

* ECHO INC’s liability under the “Lifetime” coverage is limited to furnishing parts speci ed under the PRODUCT Warranty

PERIOD section of this warranty statement for “Life” free of charge for a period of ten (10) years after the date of the complete

unit’s  nal production.

1 2 ... 15 16 17 18 19 20 21 22 23 24

Comments to this Manuals

No comments

Shindaiwa X7502800900 Operator's Manual Page 20

Comments to this Manuals

Related products and manuals for Garden tools Shindaiwa X7502800900