Shindaiwa C-35 Operator's Manual download pdf (Page 6)

TSU05

1. Remove the four socket-head cap screws (A), clamp (B)

and two shims (C) (if installed).

2. Remove the retaining nut (D), washer (E) and gearcase

clamp screw (F). If possible, do not disturb the D-washer

(G).

CAUTION!

The D-Washer is a spacer that prevents overtightening

and must remain in place to prevent possible damage to

the gearcase clamp.

3. Remove the cutting attachment shield (J) from the

gearcase.

NOTE:

Retain all hardware.

4. Remove cutting attachment shield mounting plate (H)

from cutting attachment shield.

Kit Contents

Assembly

Remove the Existing Cutting Attachment Shield.

WARNING!

A cutting attachment shield or other protective device is

no guarantee of protection against ricochet. YOU MUST

ALWAYS GUARD AGAINST FLYING DEBRIS!

Removing the Old Cutting Attachment Shield

No. Description QTY.

1. Debris Shield 1

2. Debris Shield Extension 1

3. Upper Clamp 1

4. Shims 2

5. 5 x 45 mm bolts 4

6. Safety Label 1

Assembly Tool (s)

1 2 3 4 5 6 7 8

No comments

Shindaiwa C-35 Operator's Manual Page 6