Shindaiwa T222 Operator's Manual download pdf (Page 7)

7

26013

F222

Trimmer Head

Install the Trimmer Head.

Turn the trimmer over so that the gear

case output shaft faces UP.

Remove and discard the black plastic

protective cap from the output shaft. See

Figure 10.

Rotate the holder until the hole in the

holder aligns with the notch on the

gear case. Use the long end of the hex

wrench to lock the holder and output

shaft. See Figure 10.

Remove the hex wrench.

1.

2.

3.

4.

5.

Adjust the trimmer line length to reach

no further than the line cutter on the

cutting attachment shield. Trim to the

correct length if necessary.

6.

Assembly

Figure 10

The unit should now be

completely assembled and ready

for use with a trimmer head.

Cutting Attachment Shield

Assembly and Adjustments

WARNING!

NEVER operate this unit without

the cutting attachment shield installed

and tightly secured!

Figure 9A

Figure 9B

T222

Install the shield and clamp as shown in

ﬁgure 9B.

Align the hole in the outer tube with the

locator on the cap; install the two (2)

screws ﬁnger tight.

Tighten the screws alternately to secure

the cutting attachment shield in place.

1.

2.

3.

Install the Cutting Attachment

Shield T222.

Insert the cutting attachment shield

between the outer tube and the cutting at-

tachment mounting plate. See Figure 9A.

1.

CAUTION!

Make sure the clamp screw and

retaining nut are securely tightened

before tightening the four socket-head

cap screws.

NOTE:

It may be necessary to loosen the

retaining nut and clamp screw to adjust

cutting attachment shield mounting plate.

Fit the two shims and the bracket over

the outer tube and loosely install the

four socket-head screws. See Figure 9A.

2.

Tighten the four socket-head cap screws

to secure the cutting attachment shield.

Re-tighten clamp screw and retaining nut.

3.

4.

Install the Cutting Attachment

Shield F222.

WARNING!

A standard grass trimmer

with a loop handle should NEVER be

operated with blade-type attachments.

Cutting

Attachment

Shield

Outer

Tube

Socket-

Head Cap

Screw

Bracket

Shim

Clamp

Screw

Shim

Retaining

Nut

Cutting Attachment

Mounting Plate

Line Cutter

Hex

Screws

Nuts

Outer Tube

Screws

Cutting

Attachment

Shield

Cap

Locating Hole

Figure 9C

Holder

Output

shaft

Retaining

Plug

Hex Wrench

1 2 3 4 5 6 7 8 9 10 11 12 ... 51 52

Comments to this Manuals

No comments