Shindaiwa 357 Service Manual download pdf (Page 76)

Q Shindaiwa Inc. 1995

Section 7 Cylinders and Pistons

All Models Other than 757 (Figure 7.15)

STEP 1. Lubricate the piston pin bearing and

thrust washers with a light coating of high

quality engine oil.

STEP 2. Using the appropriate alignment tool,

assemble the pin bearing and thrust

washers between the two piston bosses.

STEP 3. Using either of the following two

installation methods, assemble the piston

pin to the bearing and connecting rod.

■ While supporting the piston by hand, use a

soft-faced hammer and an appropriate

driver to install the pin in the piston pin

booses (Figure 7.16).

■ Use pin puller tool p/n 72282-96300 and

the appropriate push pin to assemble the

pin to the piston (Figure 7.17)

Reassembly

Parts Interchangeability—575-680-695

Component 575 p/n 577 p/n 680 p/n 695 p/n

Crankshaft 22150-42001 22150-42002 22150-42001 22155-42001

Piston 22152-41110 22152-41112 22150-41113 22155-41113

Piston Rings 22152-41210 22152-41210 22150-41210 22150-41210

Piston Pin 22152-41220 22152-41220 22150-41220 22155-41221

Retaining Ring 22152-41230 22152-41230 99900-01734 22155-41230

Bearing 22150-41280 22150-41280 22150-41280 22155-41281

Thrust Washer 22152-41250 22152-41250 22152-41250 NONE

300, 300S, 360,

377, 357, 488,

575,577, 680

Figure 7.16 Using a Driver Tool

Figure 7.15 Assembly Variations

695, 757

(no thrust washers)

Driver Tool

Figure 7.17 Using a Puller Tool

p/n 72282-96300

Pin Adapter

Clockwise

to install

CYLINDERS/PISTONS

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 137 138

Comments to this Manuals

No comments

Shindaiwa 357 Service Manual Page 76

Comments to this Manuals

Related products and manuals for Power chainsaws Shindaiwa 357