Shindaiwa C282 Operator's Manual download pdf (Page 12)

■ After the engine starts, allow the

engine to warm up at idle 2 or 3 min-

utes before operating the unit.

When the Engine Starts...

■ Advancing the throttle makes the cutting attachment move faster; releasing the throttle

permits the attachment to stop moving. If the cutting attachment continues to move

when the engine returns to idle, carburetor idle speed should be adjusted (see “Adjust

ing Engine Idle”).

NEVER operate the unit with the cut-

ting attachment shield or other protec-

tive devices removed!

Use only authorized Shindaiwa parts and

accessories with your Shindaiwa trimmer.

Do not make modiﬁcations to this unit

without written approval from Shindaiwa,

Inc.

ALWAYS make sure the cutting attach-

ment is properly installed and ﬁrmly

tightened before operation.

NEVER use a cracked or warped cut-

ting attachment: replace it with a ser-

viceable one.

Checking Unit Condition

ALWAYS make sure the cutting attach-

ment ﬁts properly into the appropriate

attachment holder. If a properly installed

attachment vibrates, replace the attach-

ment with new one and re-check.

ALWAYS stop the engine immediately

and check for damage if you strike a

foreign object or if the unit becomes

tangled. Do not operate with broken or

damaged equipment.

NEVER allow the engine to run at high

RPM without a load. Doing so could

damage the engine.

NEVER operate a unit with worn or

damaged fasteners or attachment

holders.

WARNING!

A cutting attachment shield

or other protective device is no guar-

antee of protection against rico-

chet. YOU MUST ALWAYS GUARD

AGAINST FLYING DEBRIS!

1. Idle the engine brieﬂy before stop-

ping (about 2 minutes).

2. Slide the ignition switch to the “O”

(Engine OFF) position.

Stopping the Engine

Starting A Flooded Engine

IMPORTANT!

When the unit is turned off make sure

the cutting attachment has stopped

before the unit is set down.

1. Slide the ignition switch to the “I” (ON) position.

2. Open the choke, put the throttle lever in the full throttle position, then clear excess fuel from the combustion chamber by

cranking the engine several times.

3. If the engine still fails to start or ﬁre, refer to the troubleshooting ﬂow chart at the end of this manual.

5. When the engine starts, slowly move

the choke lever to the “OPEN” posi-

tion. If the engine stops after the ini-

tial start, close the choke and restart.

IMPORTANT!

If the engine fails to start after several

attempts with the choke in the closed

position, the engine may be ﬂooded

with fuel. If ﬂooding is suspected, refer

to the “Starting a Flooded Engine” sec-

tion of this manual.

Open

When the engine starts, slowly move the

choke lever to the “OPEN” position

WARNING!

The cutting attachment

may move when the engine is

started! Keep your hands and your

body away from the cutter assem-

bly while starting the engine!

OFF

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 31 32

Comments to this Manuals

No comments

Shindaiwa C282 Operator's Manual Page 12

Comments to this Manuals

Related products and manuals for Garden tools Shindaiwa C282