Shindaiwa C282 Operator's Manual download pdf (Page 6)

Assembly

Prior to Assembly

Before assembling, make sure you have

all the components required for a com-

plete unit and inspect unit and compo-

nents for any damage.

■ Engine/Outer tube assembly

■ Handlebar and Throttle assembly

■ Cutting attachment shield

This unit comes fully assembled with

the exception of the handlebar, cut-

ting attachment shield and cutting

attachment.

■ Cutting attachment

■ Shoulder strap

■ Assembly Tool (s)

■ Safety Glasses

■ Operator’s Manual

■ Emission Control Warranty

Statement

IMPORTANT!

The terms “left”, “left-hand”, and

“LH”; “right”, “right-hand”, and “RH”;

“front” and “rear” refer to directions as

viewed by the operator during normal

operation.

Install the handlebar:

1. Use the 4 mm hex wrench to remove

the lower cap retaining screws from the

handlebar bracket. Remove the cap from

the bracket, and note the position of the

two spacers installed between the bracket

halves.

2. Position the handle on the outer tube

forward of Handle Positioning Label as

shown. Reassemble the lower cap to the

handlebar bracket in the reverse order of

disassembly.

3. Locate the handle in the best position for

operator comfort.

Outer Tube

Lower Cap

Retaining

Screws (A)

Handlebar

Lower cap

Handlebar

Handle Positioning Label

Spacer

Handlebar

Bracket

An Emission Control Label is located on the engine. (This is an EXAMPLE ONLY, information on label varies by en-

gine FAMILY).

PRODUCT EMISSION DURABILITY (EMISSION COMPLIANCE PERIOD)

The 50 or 300 hour emission compliance period is the time span selected by the manufacturer certifying the

engine emissions output meets applicable emissions regulations, provided that approved maintenance proce-

dures are followed as listed in the Maintenance Section of this manual.

Emission Control (Exhaust & Evaporative)

EPA 2010 and Later and/or C.A.R.B. TIER III

The emission control system for the engine is EM (engine modication) and, if the second to last character of the En-

gine Family on the Emission Control Information label (sample below) is “C”, “K”, or “T”, the emission control system

is EM and TWC (3-way catalyst). The fuel tank/fuel line emission control system is EVAP (evaporative emissions).

Evaporative emissions for California models are only applicable to fuel tanks.

1 2 3 4 5 6 7 8 9 10 11 ... 31 32

Comments to this Manuals

No comments

Shindaiwa C282 Operator's Manual Page 6

Comments to this Manuals

Related products and manuals for Garden tools Shindaiwa C282