Shindaiwa C282 Operator's Manual download pdf (Page 9)

Assembly (continued)

1. Turn the unit upside down so the

gear case output shaft is facing UP

and remove the shaft bolt, bolt guard

and holder B from the gear case

shaft.

2. Align the hole in blade holder A with

the matching hole in the gear case

ﬂange and then temporarily lock

the output shaft by inserting a hex

wrench through both holes.

3. Fit the blade over the ﬂange on holder

Shaft Bolt

Bolt Guard

Holder B

Gear Shaft

Holder A

Hex wrench

Temporarily lock the output shaft by

inserting a hex wrench through both holes

Install blade holder B on the output shaft.

Blade

Blade Holder B

Output

Shaft

WARNING!

The blade must t at

against the holder ange. The

blade mounting hole must be cen-

tered over the raised boss on blade

Holder A.

WARNING!

Holder B must t ush

against the blade and the splines

engaged to the output shaft.

WARNING!

Do not attach any blade to

a unit without proper installation of

all required parts. Failure to use the

proper parts can cause the blade to

y off and seriously injure the oper-

ator and/or bystanders.

4. Install blade holder B on the output

shaft.

Installing Brushcutter Blade

Hex Wrench

Tighten the assembly

(blade not shown for

clarity)

CAUTION!

Install the blade so its printed sur-

face is visible to the operator when

the brushcutter is in the normal

operating position.

The unit should now be

completely assembled and

ready for use with a blade.

IMPORTANT!

Discard blades that are bent, warped,

cracked, broken or damaged in any way.

Use a sharp blade. A dull blade is more

likely to snag and thrust.

5. Install the bolt guard and then the

blade retaining bolt. Using the com-

bination spark plug wrench/screw-

driver, tighten the bolt ﬁrmly in a

counter-clockwise direction.

6. Remove the hex wrench.

Using the combination spark plug wrench/

screwdriver, tighten the bolt rmly in a

counter-clockwise direction.

WARNING!

Alternative fuels, such as E15 (15% ethanol), E-85 (85% ethanol) or any fuels not meeting Shindaiwa

requirements are NOT approved for use in Shindaiwa gasoline engines. Use of alternative fuels may cause

performance problems, loss of power, overheating, fuel vapor lock, and unintended machine operation, including,

but not limited to, improper clutch engagement. Alternative fuels may also cause premature deterioration of fuel

lines, gaskets, carburetors and other engine components.

Mixing Fuel

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

Comments to this Manuals

No comments

Shindaiwa C282 Operator's Manual Page 9

Comments to this Manuals

Related products and manuals for Garden tools Shindaiwa C282