Shindaiwa T272X User Manual download pdf (Page 9)

9

NEVER smoke or light res near the

engine.

ALWAYS stop the engine and allow it

to cool before refueling.

ALWAYS Wipe all spilled fuel and move

at least 3 meters from the fueling point

and source before starting.

ALWAYS inspect the unit for fuel leaks

before each use. During each rell,

check that no fuel leaks from around

the fuel cap and/or fuel tank. If fuel

leaks are evident, stop using the

unit immediately. Fuel leaks must be

repaired before using the unit.

ALWAYS move the unit at least 3

meters away from a fuel storage area

or other readily ammable materials

before starting the engine.

NEVER place ammable material close

to the engine mufer.

NEVER operate the engine without the

mufer and spark arrester screen in

place.

Mixing fuel

Place the unit on a ﬂat, level surface.

Clear any dirt or other debris from

around the fuel ﬁller cap.

Remove the fuel cap, and ﬁll the tank

with clean, fresh fuel.

Reinstall the fuel ﬁller cap and tighten

ﬁrmly.

1.

2.

3.

4.

Filling the fuel tank

CAUTION!

This engine is designed to operate on

a 50:1 mixture consisting of unleaded

gasoline and ISO-L-EGD or JASO FC

class 2-cycle mixing oil only. Use of

non-approved mixing oils can lead to

excessive carbon deposits.

CAUTION!

Never use any type of gasoline

containing more than 10% alcohol

by volume! Some types of gaso-

line contain alcohol as an oxygen-

ate. Oxygenated gasoline may

cause increased operating temper-

atures. Under certain conditions,

alcohol-based gasoline may also

reduce the lubricating qualities of

some 2-cycle mixing oils.

Generic oils and some outboard

oils may not be intended for use

in high-performance two-cycle en-

gines, and should never be used

in your Shindaiwa engine.

■

■

Use only fresh, clean unleaded gasoline

with a pump octane of 87 or higher.

Mixed with 50:1 Shindaiwa ISO-L-

EGD or JASO FC class 2-cycle mixing

oil at a gasoline/ratio of 50:1 (1 gal-

lon of gasoline to 2.6 ozs mixing oil).

Shindaiwa One meets or exceeds these

requirements.

■

■

Examples of 50:1 mixing quantities

WARNING!

Minimize the Risk of Fire

IMPORTANT

Mix only enough fuel for your immediate

needs! If fuel must be stored longer than

30 days, it should ﬁrst be treated with a

fuel stabilizer such as STA-BIL™.

Gasoline 2-cycle mixing oil

liters milliliters

2.5 - 1

50 ml

5 - 1 100 ml

10 - 1 200 ml

20

- 1 400 ml

Oil is a registered JASO FC classiﬁed

oil and also meets or exceeds ISO-

L-EGD performance requirements.

Shindaiwa One is recommended for

use in all Shindaiwa low emissions

engines. Shindaiwa One also includes

a fuel stabilizer.

1.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 39 40

Comments to this Manuals

No comments