Shindaiwa AH2510 Operator's Manual download pdf (Page 10)

10

Idle the engine brieﬂy before stopping

(about 2 minutes), then slide the ignition

switch to the “O” (Engine OFF) position.

Stopping the Engine

Adjusting Engine Idle

Figure 23

Figure 24

OFF

The engine must return to idle speed

whenever the throttle lever is released.

Idle speed is adjustable, and must be set

low enough to permit the engine clutch to

disengage the cutting attachment.

WARNING!

The cutting attachment must NEVER

oscillate at engine idle! If the idle speed

cannot be adjusted by the procedure

described here, return the unit to your

Shindaiwa dealer for inspection.

1. Place the unit on the ground and start

the engine, then allow it to idle 2-3 min-

utes until warm.

2. If the cutting attachment oscillates

when the engine is at idle, reduce

the idle speed by turning the idle

adjustment screw counter-clockwise.

See Figure 24.

Idle Speed Adjustment

3. If a tachometer is available, the engine idle

speed should be ﬁnal adjusted to 3,000

(±300) rpm (min

-1

).

NOTE:

Carburetor fuel mixture adjustments are

preset at factory and cannot be serviced in

the ﬁeld.

Idle Adjusting

Screw

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Comments to this Manuals

No comments