Shindaiwa AH2510 Operator's Manual download pdf (Page 6)

6

Assembly: AH2510

Grip

Spark Plug

Trigger

Housing

Mainshaft

Tube

Clamp

Outer Tube

1. Place the powerhead on a clean, ﬂat

surface, spark plug facing up.

2. Use the 4 mm hex wrench to loosen the

tube clamp screw.

Tube Clamp

Hex

Wrench

Connect the Outer Tube

to the Powerhead.

Clamp Screw

3. Slide the outer tube into the tube clamp

until the tube bottoms. If installation

is difﬁcult, rotate the outer tube or

main shaft slightly until you feel the

mainshaft splines engage with the

powerhead.

4. Position the outer tube so that the

gearcase output shaft is facing left on

mufﬂer cover.

5. Slide the outer tube into the powerhead

until the throttle grip just contacts the

tube clamp.

6. Tighten the clamp screw ﬁrmly.

Figure 5

Figure 6

Throttle Cable

CAUTION!

Do not force the shaft tube into the

powerhead! Excessive force can dam-

age the shaft tube and mainshaft.

Connect the Throttle Cable

1. Loosen the air cleaner cover knob

and remove the air cleaner cover.

See Figure 7.

2. Slip the throttle cable into the cable

adjuster and hook the bullet end of the

cable onto the swivel. See Figure 8.

Connect the Ignition Leads

3. Connect the two ignition wires by

pushing the bullet connectors together.

See Figure 9.

4. Reinstall the air cleaner cover.

Connect the throttle

cable

Ignition

Lead

Figure 8

Figure 7

Throttle

Cable

Cable

Adjuster

Filter

Cover

Figure 9

Cable Swivel

CAUTION!

Routing of wiring must not interfere

with throttle or choke operation.

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Comments to this Manuals

No comments