Shindaiwa HT230 Operator's Manual Page 14

  • Download
  • Add to my manuals
  • Print
  • Page
    / 60
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 13
14
Gearcase Lubrication Schedule
Every 20 Hours
Connect a grease gun to the grease fitting
on the left side of the gearcase. Top off
the gearcase grease level by adding a
high quality lithium-based grease. Three
pumps of the grease gun handle should
be adequate. DO NOT OVERFILL THE
GEARCASE!
Long Term Storage
n Thoroughly clean the exterior of the
machine.
n Remove all clippings and other debris
from the cylinder fins and other
components (as previously described
under Daily Maintenance).
n Drain all unused fuel from the fuel tank,
and then clear the carburetor and fuel
lines by running the trimmer until it
stops from lack of fuel.
IMPORTANT!
All stored fuel should be stabilized with
fuel stabilizer such as STA-BIL™
CAUTION!
Make sure you do not pierce the
fuel line with the end of the hooked
wire. The line is delicate and can be
damaged easily.
50-Hour Maintenance
Remove the gearcase cover. Use solvent
and a soft brush to remove all old grease
from the gearcase. To refill, hand-pack
the gearcase with approximately 40–50
grams of high quality lithium-based grease
(50–70% of capacity). DO NOT OVERFILL!
n Use a hooked wire to extract the fuel
filter from inside the fuel tank. Inspect
the fuel filter element. If it shows signs
of contamination from debris, replace it
with a genuine Shindaiwa replacement
fuel filter element. Before reinstalling
the filter, inspect the fuel line. If you
discover damage or deterioration, the
unit should be removed from service
until it can be inspected by a Shindaiwa-
trained service technician.
(30 days or longer)
CAUTION!
Over-lubricating may cause the
gearcase to run slower than normal,
and may also cause leakage from
excess grease.
CAUTION!
Never store this unit with any fuel
remaining in the tank, fuel lines or
carburetor!
NOTE:
Your Shindaiwa warranty does not include
coverage for damage caused by stale or
contaminated fuels.
n Remove the spark plug, and pour about
7 grams of 2-cycle mixing oil into the
cylinder through the spark plug hole.
Before reinstalling the spark plug,
slowly pull the recoil starter 2–3 times to
distribute the oil over the cylinder wall.
n Service the air cleaner element as
previously described in the daily
maintenance section of this manual.
n
Repair or replace any damaged
components as required, and then store
the unit in a clean, dry, and dust-free area.
(more frequently in dusty or dirty
conditions or before long-term storage):
VIEWED FROM THE BOTTOM
Gearcase
Grease
Fitting
VIEWED FROM THE BOTTOM
DO NOT REMOVE
CONRODS!
Gearcase
Cover
socket-head
Capscrews
Hooked
Wire
Filter Element
Page view 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 59 60

Comments to this Manuals

No comments