Shindaiwa DH212 User Manual download pdf (Page 10)

ENGLISH

Install blade stIffener

Move stop switch to stop position.

Disconnect spark plug wire.

WARNING

Hedge trimmer blades are very sharp. Touching them may lead to

severe personal injury. Use a socket and extension when adjust-

ing blade bolts or blade locknuts in order to keep hands at a safe

distance from sharp blades.

Lay unit on mufer side and hold securely in place.

Remove rst four blade locknuts (A) and washers in front of

front handle/guard. Do not remove blade bolts.

Tighten blade bolts (B) until snug. Install blade stiffener, then washers.

Loosen blade bolts ½ turn. Secure blade stiffener with new locknuts

(A). Hold blade bolts from turning using a 10mm wrench.

NOTE

Use new locknuts every time blade stiffener is installed.

IMPORTANT

If blade stiffener is damaged or show signs of wear, replace it.

NOTE

Washers (C) should be movable by hand after blade bolts are

adjusted properly.

blade stIffener remoVal

Move stop switch to stop position.

Disconnect spark plug wire.

WARNING

Hedge trimmer blades are very sharp. Touching them may lead to

severe personal injury. Use a socket and extension when adjust-

ing blade bolts or blade locknuts in order to keep hands at a safe

distance from sharp blades.

Remove blade stiffener locknuts (A) and washers. Do not remove

blade bolts.

Remove blade stiffener.

Tighten blade bolts (B) until snug, then loosen ½ turn.

Secure blades with new locknuts (A). Hold blade bolts from turning

using a 10mm wrench.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 95 96

No comments

Shindaiwa DH212 User Manual Page 10