Shindaiwa EB802RT User Manual download pdf (Page 18)

18

Troubleshooting Guide

ADDITIONAL PROBLEMS

Fuel tank empty.

Clogged fuel ﬁlter.

Water in the fuel.

Shorted spark plug or loose terminal.

Ignition failure.

Piston seizure.

Ground (stop) wire is disconnected or

switch is defective

Overheating due to incorrect spark

plug

Clogged air ﬁlter.

Clogged fuel ﬁlter.

Lean fuel/air mixture.

Idle speed set too low.

Ignition switch turned off.

Refuel. See Fuel section of manual.

Replace fuel ﬁlter.

Drain; replace with clean fuel. See Fuel

section of manual..

Clean or replace spark plug. Check

the Speciﬁcations page in this manual

for the proper spark plug for your unit.

Tighten the terminal.

Replace the ignition unit.

Consult with an authorized servicing dealer.

Test and replace as required.

Replace the spark plug. Check the

Speciﬁcations page in this manual for

the proper spark plug for your unit.

Clean or replace the air ﬁlter.

Replace the fuel ﬁlter.

Consult with an authorized servicing dealer.

Reset the switch and re-start.

Overheated engine.

Debris build up in impeller.

Loose or damaged impeller.

Idle engine until cool.

Clean debris from impeller as required.

Inspect and replace impeller as required.

Loose or damaged engine mounts.

Blower intake or discharge ports or

tubes are clogged with debris..

Impeller blades are missing or

damaged.

Tighten or replace engine mounts as required.

Inspect and remove debris.

Consult with a authorized servicing dealer.

What To Check Possible Cause Remedy

Poor acceleration.

Engine stops abruptly.

Engine difﬁcult to shut off.

Excessive vibration.

Engine overspeeding.

Adjust: 2,000 (±200) min

-1

.

Heat sensor is activated, due to

restricted air ﬂow at intake cover.

Stop the engine. Clean debris blocking

intake cover. Restart. Idle more than 1

minute. If engine speed is reduced again,

consult with an authorized servicing

dealer.

Engine speed is reduced.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 59 60

Comments to this Manuals

No comments