Shindaiwa EB802RT User Manual download pdf (Page 7)

7

Throttle Cable Holder

Static Wire

Connector

Static Wire

Fold Wire

Flexible Tube

Swivel

Tube

Throttle

Assembly

Throttle Cable

Holder

Loops

Lock Pin

Lock Slot

Rotate clockwise to lock making

sure the 3 lines are aligned on

both tube and nozzle.

Align the lock pins with the lock

slots, and push the tube and

nozzle together.

A

B

Assembling the RT Blower

IMPORTANT!

Blower tube installation affects blower

performance! Make sure the tubes and

nozzle are correctly assembled per above,

and that all connections are tight. Blower

tubes may come apart during use unless

tubes are aligned and locked into place.

Figure 7

Figure 9

Place the blower upright on the ground

or a sturdy work surface and note parts

orientation as shown in Figure 7.

Remove static wire from package and

ﬁx eyelet to right hand engine cover

screw. See Figure 8.

Turn the discharge tube out to a right

angle and slip anti-static wire through

the 102mm clamp and ﬂexible tube.

Install throttle cable holder just forward

of the 102 mm clamp, pinching loops

together to ﬁt over end of ﬂexible tube.

See Figures 10A and 10B.

Slip the ﬂexible tube over the end of the

90° discharge tube, and secure with the

102 mm clamp.

Slide the throttle assembly over the swivel

tube. Do not tighten clamp at this time.

1.

2.

3.

4.

5.

6.

WARNING!

Danger from rotating

impeller!

Stop the engine before installing or

removing the blower tubes! Never

perform any maintenance or assem-

bly procedures on this unit while the

engine is running!

IMPORTANT!

This unit is equipped with a static dis-

charge reduction wire. This wire helps

direct static buildup into the air stream

reducing the felt amount to the operator.

Figure 8

Figure 10B

Insert the static wire through the swivel

tube, then install and tighten the 89mm

clamp over the rotating band on the

swivel tube.

Fold the end of the static wire back over

the connection of the swivel tube. See

Figure 8.

Grasp the nozzle, and push the nozzle

over the swivel tube locking pins secur-

ing the static wire. See Figure 9.

Lock the nozzle to the swivel tube by

rotating the nozzle noting the alignment

marks. See Figure 9.

Adjust throttle assembly for best operator

comfort and tighten two socket-head

screws.

7.

8.

9.

10.

11.

Flexible Tube

Throttle

Assembly

89mm Clamp

102mm

Clamp

Swivel Tube

Straight Tube

Short Nozzle

(ø65 mm)

Swivel

Tube

90° Discharge

Tube

Anti-Static

Wire

Throttle Cable

Holder

Long Nozzle (ø74 mm)

Figure 10A

NOTE:

Check to make sure that the 90° dis-

charge tube swivels freely. If any binding

is present, loosen 102 mm clamp and

pull wire towards engine to get more

slack and recheck for free movement.

The blower should now be ready

for use.

Assembly (continued)

1 2 3 4 5 6 7 8 9 10 11 12 ... 59 60

Comments to this Manuals

No comments