Shindaiwa AH2510 Operator's Manual download pdf (Page 10)

1. Clean outer tube so the labels will adhere properly.

2. Peel the backing off the multiple warning label and attach below similar label on

lower part of outer tube. Make sure label faces up and that it is legible from the

operator's position.

3. Peel the backing off "The Electrical Shock Danger" label and attach it just ahead of

the throttle grip. Make sure the label faces up and that it is legible from the opera

tor's position.

Installing the Hand Protector

WARNING!

■ The provided labels offer important safety information about hedge trimmers.

Do not operate, or allow others to operate, this machine unless the labels are

properly installed.

Installing the Hedge Trimmer Cutter Assembly

1. Measure 24-1/2 in. (622 mm) from the bottom end of the outer tube and make a

mark on the tube.

2. Slide the hand protector/cutter rest (A) up the outer tube, making sure its pro-

truding collar (B) faces toward the end of the tube and its clamp slot faces down.

3. Position the hand protector/cutter rest so the front of the protruding collar aligns

with the mark on the outer tube.

4. When positioned properly, the end of the cutter bar will ﬁt into the notch (C) on

the hand protector.

5. When the proper location is set, tighten the clamp screw with a screwdriver.

1. Make sure the cutter bar is locked in the storage/transport position (folded

back) and the protective cover is installed over the cutter blades (F).

2. Remove index screw (D).

3. Insert the end of the outer tube into the gear case clamp assembly and push

until it bottoms. The outer tube should go into the gear case about 1-1/2 in. (38

mm). If the outer tube stops before bottoming, rotate it until you feel the inner

main shaft (drive shaft) splines engage the gear case. Then push the outer tube

all the way in.

4. Rotate the gear case/cutter assembly so that index screw hole aligns with the

hole in the outer tube. With the power head in the upright position, the cutter as-

sembly will appear to be upside down (while in the storage/transport position).

5. Install and tighten the index screw ﬁrst, then tighten the gear case clamp screw

(E).

6. Adjust the hand protector/cutter rest so that the tip of the cutter bar ﬁts into

the support notch (C). Make sure the cutter bar also lifts out of the notch easily.

Then tighten the hand protector clamp screw with screwdriver.

Installing the Caution Labels

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

No comments

Shindaiwa AH2510 Operator's Manual Page 10