Shindaiwa AH2510 Operator's Manual download pdf (Page 9)

1/4”

3. When 1/4-inch of free play is achieved, securely tighten the two 10mm throttle

cable nuts. When the throttle cable is correctly adjusted, and the throttle trigger

is fully depressed (full throttle), the throttle will contact the stop on the throttle

body (F).

NOTE:

Apply anti-seize oil on the cylinder cover knob threads for easier removal.

4. Replace the cylinder cover.

5. Replace the spark plug boot.

IMPORTANT!

Make sure the stop switch wires do not interfere with throttle functions.

Reposition wires if necessary.

2. Adjust the throttle cable nuts until you achieve a free play on the throttle trigger

of about 1/4 inch.

1. Place the re-gripped T230 or PB230 on a clean, ﬂat surface in an upright position.

For the T230/T231 Trimmers:

2. Loosen, but don't remove the gearcase clamp screw (A) and nut using a 4 mm

hex wrench and an 8 mm open end wrench.

3. Use the 4 mm hex wrench to loosen the gearcase index screw (B) until it is

almost free.

4. Use the 4 mm hex wrench to loosen the four debris shield attachment screws (C). Loosen

them only enough to free the debris shield assembly from the outer tube. This will make it

easier to reattach the debris shield when converting back to a trimmer.

5. Pull and rotate the debris shield, gearcase, and trimmer head assembly until it slides

off the outer tube.

NOTE:

The gearcase and debris shield are connected by the clamp screw.

6. The debris shield has two shims (D) located on either side of the outer tube and

the debris shield bracket. Put the shims and the debris shield/gearcase assem-

bly in a safe place, so that they can be reinstalled later if desired.

Removing the Trimmer/PowerBroom Attachment

For the PB230 PowerBroom:

1. Using a 5 mm hex wrench and a 10 mm open end wrench, loosen, but don't remove, the

gearcase clamp screw.

2. Using the 4 mm hex wrench, back out the index screw until it is almost free.

3. Pull and rotate the gearcase/sweeper drum assembly until it slides off the outer tube.

4. Remove the spacer from the outer tube if it did not slide off with gearcase/ sweeper drum

assembly. Put the spacer and gearcase/sweeper drum assembly in a safe place, so they

can be reinstalled later if desired.

5. If your PB230 is equipped with the optional guard assembly, it must be removed. Use 4 mm

hex wrench to remove its four clamp screws. Slide the protective collar off the outer tube.

NOTE:

For help reinstalling the original gearcase and attachments, consult the owner's manual

that came with your T230, T231, or PB230.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Comments to this Manuals

No comments

Shindaiwa AH2510 Operator's Manual Page 9

Comments to this Manuals

Related products and manuals for Power hedge trimmers Shindaiwa AH2510