Shindaiwa AH2510 Operator's Manual Page 15

  • Download
  • Add to my manuals
  • Print
  • Page
    / 20
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 14
15
P23007
E
4. Choke the engine by moving the choke lever (E) up to the “closed” position.
Control Positions (warm engine)
1. Set the throttle trigger to “fast idle”
2. Slide the ignition switch to the “I” (ON) position.
3. Move the choke lever down to the “open” position.
WARNING!
Before performing any maintenance,
repair, or cleaning work on the unit,
make sure the engine and cutting
attachment are completely stopped.
Disconnect the spark plug wire
before performing service or mainte
-
nance work.
IMPORTANT!
For detailed maintenance information
about your
T230/231, or PB230, consult
the owner's manual that was provided
with it. If it has been lost or misplaced,
contact Shindaiwa for a replacement.
Maintenance
WARNING!
Non-standard parts may not oper-
ate properly with your unit and may
cause damage and lead to personal
injury.
IMPORTANT!
Using non-standard replacement parts
could invalidate your Shindaiwa war-
ranty.
Daily Maintenance
WARNING!
Always wear gloves when working
around the cutter assembly.
Prior to each work day, perform the follow-
ing:
Clean any debris or dirt from the
hedge trimmer cutter blades.
Lubricate the blades before use and
after refueling. Check the cutters for
damage or incorrect adjustment.
Check for loose or missing screws
or components. Make sure the
cutter attachment is free of debris
and securely fastened.
Check the entire machine for
leaking fuel or grease.
Make sure the nuts, bolts, and
screws (except carburetor adjusting
screws) are tight.
10/15-Hour Maintenance
Lubricate the cutter assembly
gearbox by pumping one or two
strokes of lithium-base grease into
the grease tting (A) using a lever-
type grease gun.
A
CAUTION!
Overlubricating can cause the gear-
case to operate sluggishly and can
cause grease to leak out.
Page view 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments