Shindaiwa EB802RT User Manual download pdf (Page 13)

To remove the cover, loosen the

thumbscrews and lift.

Air Cleaner

Element

Cover

Pre-Filter

Thumbscrews

Remove the air cleaner cover by loosen-

ing the thumbscrews and lifting. See

Figure 21.

Remove and inspect the pre-ﬁlter. If the

pre-ﬁlter is torn or otherwise damaged,

replace it with a new one.

1.

2.

IMPORTANT!

The blower uses a special high capac-

ity dry-type air ﬁlter element. The ﬁlter

should not be cleaned with a liquid cleaner

and must NEVER be oiled!

Clean the pre-ﬁlter with soap and water.

Let dry before reinstalling.

Inspect the air cleaner element. If

the element is damaged or distorted,

replace it with a new one.

3.

4.

Figure 21

13

IMPORTANT!

MAINTENANCE, REPLACEMENT

OR REPAIR OF EMISSION CONTROL

DEVICES AND SYSTEMS MAY BE PER-

FORMED BY ANY REPAIR ESTABLISH-

MENT OR INDIVIDUAL, HOWEVER,

WARRANTY REPAIRS MUST BE PER-

FORMED BY A DEALER OR SERVICE

CENTER AUTHORIZED BY SHINDAIWA

CORPORATION THE USE OF PARTS

THAT ARE NOT EQUIVALENT IN PER-

FORMANCE AND DURABILITY TO

AUTHORIZED PARTS MAY IMPAIR

THE EFFECTIVENESS OF THE EMIS-

SION CONTROL SYSTEM AND MAY

HAVE A BEARING ON THE OUTCOME

OF A WARRANTY CLAIM.

Maintenance

Daily Maintenance

WARNING!

To reduce re hazard, keep

the engine and mufer free of dirt,

debris, and leaves.

WARNING!

Non-standard parts may

not operate properly with your unit

and may cause damage and lead to

personal injury.

NOTE:

Using non-standard replacement parts

could invalidate your Shindaiwa warranty.

Every 10 Hours

(more frequently in dusty conditions)

CAUTION!

Never operate the blower if the air

cleaner assembly is damaged or

missing!

Inspect the engine, tank, and hoses

for possible fuel leaks, and repair as

necessary.

Inspect the entire blower for loose,

damaged, or missing components, and

repair as necessary.

Carefully remove any accumulations

of dirt or debris from the mufﬂer and

fuel tank. Dirt build-up in these areas

can lead to engine overheating, ﬁre or

premature wear.

■

■

■

IMPORTANT!

Direct the air stream at the inside face of

the ﬁlter only!

WARNING!

Before performing any

maintenance, repair or cleaning work

on the unit, make sure the engine is

completely stopped. Disconnect the

spark plug wire before performing

service or maintenance work.

CAUTION!

The engine is cooled by air drawn

into the air intake cover on the

blower housing. The blower fan then

pushes the cooling air through an

opening in the fan housing, forcing it

past the cylinder cooling ns. Failure

to keep the cooling system and its

passages clear of debris will likely

result in engine overheating, a major

cause of serious engine problems

that can lead to failure.

Prior to each workday, perform the

following:

Remove all dirt and debris from blower

exterior and the engine. Check the

cooling ﬁns and air cleaner for clog-

ging and clean as necessary.

■

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 59 60

Comments to this Manuals

No comments