Shindaiwa HT230 Operator's Manual download pdf (Page 8)

8

DH230

(1) Attaching the Rear Handle

to the Gearcase Assembly

1) Slide the rear handle onto the rear ﬂange of

the cutter/gearcase assembly. Make sure

the throttle cable and ignition and ground

wires do not bind during assembly.

2) Make sure the mating holes between the

rear handle and the gearcase are aligned,

then secure the rear handle using two

6mm x 35mm socket head cap screws and

washers.

IMPORTANT!

The washers used on the front handle

and the rear handle are not the same.

The washers for the rear handle are black

for identication.

Incorrect

assembly

could expose

the operator

to serious

injury! Read

and follow

assembly

instructions

WARNING!

Collar

Rear

Handle

Cushion

Cushion

Before attaching the rear handle,

make sure the rear handle

cushions are located correctly.

Viewed from

the bottom

Throttle Cable,

Ignition and Ground

Wires

Rear Handle

Assembly

Cutter/Gearcase

Assembly

6mm x 35mm

Socket Head

Capscrews and

Washers (washers

black for identication)

(2) Install the Front Handle

1) Locate the front handle onto the cutter/

gearcase assembly as shown.

2) Secure the handle using two 6mm x 35mm

socket head capscrews and washers.

(3) Installing the Powerhead on

the Gearcase

Orient the gearcase assembly and power-

head as shown and secure with the three

6mm x 16mm screws (Screws A, B, and C).

1) Securely tighten Screws A and B.

2) Push Screw C through the eye termi-

nal in the throttle control ground wire

(black), and then install and ﬁrmly

tighten the screw to the powerhead.

6mm Nuts and Washers

Front Handle

Screw C

(6 x 16mm)

Powerhead

Screws A and B

(6 x 16mm)

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 59 60

Comments to this Manuals

No comments